BULLETS rubber MOLDS to create...
BULLETS rubber MOLDS to create endless amount of bullets and bullet shells. Valid for most of the scales.
Warning: Last items in stock!
Availability date: 11/09/2015
With this product, you earn 12 loyalty point(s). 12 point(s) = 0,30 €.
Overall Dimension of the mold: 6x12cm (2,5x5 inches)
Mold thickness: 5mm
Resistant to temperatures up to 240ºC
Contains 1 mold with bullets and bullet shells in 5 different sizes (2, 2'5, 3, 4 and 5mm length)
HOW TO USE IT:
Due to the depth of the mold, and the complexity of the pieces, in order to get the most bullets as possible each time, we recommend filling each hole of the mold 1 by 1. The process would be as follows:
1.- Knead the Putty/Clay into a ball
2.- Press the ball against the mold with any blunt object, for example the edge of a Rolling pin, trying to fill the holes of the desired bullets.
3.- Push the Putty/Clay into the bullets holes of the mold 1 by 1 by using any tool with of round tip or a toothpick. Best for this would be a Stylus tool (LINK).
4.- Remove excess of Putty/Clay with a SCRAPPER (LINK) to clean the mold without cutting it.
5.- Repeat step 2 and 3 at least 3 times. The better the mold is filled, and the more times we repeat the entire process, the better quality and the more perfect bullets we would get. If the process is not done properly, some bullets will just come out incomplete.
As something additional, once the mold is filled and while we still have the Putty/Clay in fresh conditions, in order to get more detail in the pieces, bullets may be punctured with the tip of a mechanical pencil or even a small tube, to mark the firing pins in the back of the bullets.
Paint Set - BLACK and WHITE
One Eyed - SteamPunk GOGGLES - Copper
Rubber Steel Sheet - Self Adhesive
Green Stuff Tape 15cm (6 inches) WITH GAP...
Airbrush Fabric Hose G1/8H G1/8H
Plastic Bases - Square 40mm
Valid for brush and airbrush.
Miniature Leaf Punch perfect to create...