PROJECTSPainted figures, sculptures and scale modeling projects

There's Wall - DOH!

As I begin to prepare the table for our next Frostgrave game, still a few weeks off, I was laying out my buildings & thought, there just doesn't seem to be enough terrain to block archers from shooting across the board.

Then I began to think about alleys, a harbour, etc. So how do I create an effect of raised areas with cobblestones, & stone walls easily.

Some time ago I had managed to save some pink foam from going to a landfill, asking the guys on the site if I may take some of their scraps. It's been stashed away for the most part.

Taking a larger piece, I decided on a size & keeping it simple for my test, just created a rectangular piece with a ramp to allow wagons to reach it.

Then I had the issue of how to make a pattern (which wouldn't take me all day)

I then remembered the cobblestone/flagstone rollers I got from Greenstuff World.

Category: Modeling and sculpture Terrains Landscapes Fantasy

time for the leap of faith

Ok, time for the leap of faith. I rolled the roller using a fair bit of weight across the foam & sure enough the pattern transferred!!!

DSC00767

I am guessing this would not work on the usual white foam packaging, it needs to be the good quality insulation.

DSC00768


Final

Once the patterning was done, it was a coat of black gesso to seal the foam. Then coats of Charcoal Grey, Dove Grey, Yellow Ochre & finally Gravel, going lighter drybrushing as I went.

Below is the final product, thrown on the table & covered with some terrain 

DSC00769

It's my hope that with these raised platforms it will create some more channelled avenue's for the warbands, as well as blocking lines of sight from the dreaded long shots by archers. Yes I am notorious for this myself!

DSC00770

I plan on building some more once I dig the foam from the crawlspace. Perhaps with ramps close to the edge (for a harbour/dock setting) & maybe even some curved walls.  

DSC00771

I am even thinking of perhaps building some basements into 1 or 2 with fixed buildings ruins, with the added bonus of perhaps entrances to sewers & catacombs!

DSC00772

 

I am quite satisfied with the result. The roller applies a surface just deep enough to allow the weathering of the pattern to stand out & was quite a time saver!

DSC00775

 

I have a couple more fountains in the works, I think one will have a ruined statue once I figure how best to cut the figure. As well I just primed the 3 boars I purchased from Malifeaux, so expect to see them in the next couple weeks.

Thanks for stopping by!

 


Would you like to comment?