This is the first of a series of assembly and painting tutorials to be held for "RAYGUN", a company dedicated to the manufacture of high quality parts and detailed resin.
We begin with a few simple and raygun parts list of parts and tools required for this are as follows.
Inside the hole sanded. Screw coupling stick with superglue or glue a + b. We hit the trigger and we cover the joints with putty.
We make insert to fit the bolts. Glued the screw.
We add ons. We construct a gauge,with a circles and small strips of plasticard..
We started the paint job, to do so the first thing we do is with a little solvent and paper, gently clean all parts, without rubbing because the solvent can damage the piece, we can also use alcohol.
Then we will give you a first hand way above primer, we will consider that it is better to give a pair of hands that cover details for wanting to give too thick a layer of paint.
Two or three layers of paint coats after.
Now with a very fine sanding sponge, go over the whole piece to remove any traces of paint dust if you have spray-painted or airbrushed and if you did it to brush strokes possible match.
It's time to retouch any defects that come to light now with the primer, we will use putty, we will cover any damage and once this is dry, with a very fine water paper will review caulked areas.
